Get PC error-free in minutes
Recently, some users reported that they stumbled upon the graphics cooler troubleshooter. If the siphon trigger is low, it could indicate a brine flow problem, low coolant level, clogged proportioner, clogged filters, great cooler oil level, or possibly a faulty pressure gauge. In small amounts, liquid coolant dilutes some oils and contributes to failure.
By closing our message or continuing to use our site, you agree to our Cookie Guarantee Plan. More information
Here you will find information about the most common problems with the water cooler, as well as a guide on how to fix them. There are the following 3 important questions.
The entire compressor cylinder body wears a lot, or the cylinder simply has too much play. With the compressor turned off, gasoline is discharged into the condenser, and then with the appropriate refrigerant filter, the drier, because the viscosity of gasoline is greater, through the filters, I would say the drier is clogged, too much The oil at the inlet of the filters becomes clogged, so that the refrigerant itself cannot be distributed normally.
During operation, a lot of refrigerant oil remains in the water of the cooling system, so it acts as a cooling effect, and also has the ability not to cool, so it isIn practice, refrigerant oil should be disposed of.
Now the clogging of the filter with grease should be replaced with a new filter, while the high pressure nitrogen gas enters the condenser as an oil and refrigerant gas storage element, preferably in the nitrogen gas channel using an electric hair dryer. heat up the condenser.
What are the 4 main components of a chiller system?
Chillers consist of four simple components; evaporator, compressor, this condenser and expansion group. Every refrigeration system contains a refrigerant.
Installing behind a high efficiency oil separator can significantly reduce the amount of oil entering the pipeline.
If there is already an oil film in the system, nitrogen purge can bemust be done at different times until the fog fuel is gone
The main cause of ice blockage is that the water cooler contains excessive moisture. When the refrigerant circulates in good condition, the moisture gradually re-concentrates in the water cooler, while the outlet of the nozzle contains water due to most of the lowest temperature at the icing point throttling point and the capillary tube is clearly clogged to some extent, the refrigerant may not be released.
What causes chiller to trip?
Low emotional stress – Caused by low refrigerant levels, breakage of the capillary of the power supply; reduce or completely eliminate the flow of water; clogged water filter or strainer; Antifreeze or magnetic coating on the tubes of this evaporator leads to low efficiency.
Risoluzione Dei Problemi Dei Refrigeratori Grafici
Grafico De Solucion De Problemas De Enfriadores
Het Oplossen Van Problemen Met Grafiekkoelers
Felsokning Av Diagramkylaggregat
Shema Ustraneniya Nepoladok Chillerov
Rozwiazywanie Problemow Z Agregatami Wykresowymi
Resolucao De Problemas De Resfriadores Graficos
Fehlersuche Bei Diagrammkuhlern
Tableau De Depannage Refroidisseurs
차트 냉각기 문제 해결